Employee Notification Settings β Voice DND and Ring Volume
HyperConnect lets each employee control two personal voice notification preferences: Voice Do Not Disturb (DND) and ring volume. When Voice DND is active, the employee stops receiving inbound calls while logged in, and other available agents continue to receive them. Ring volume controls how loud the ringing sounds for inbound calls on that employee's session. Both settings are stored per employee and persist across sessions.
Note: These are employee-level settings, not center-level settings. Each employee configures their own preferences independently.
Audience: Any HyperConnect user who handles voice calls.
Before you begin
- Your organization must have HyperConnect provisioned and voice calls enabled.
- You must have the Connect Access Enable permission to access HyperConnect settings.
Permission: Connect Access Enable β Required to access HyperConnect and its user settings. Admin path: Organization > Security > Security Roles > [your role] > Zenoti HyperConnect > Connect Access Enable
Steps
Configure Voice DND
Voice DND lets you stop receiving inbound calls without logging out. When DND is on, a banner appears at the top of the HyperConnect interface reminding you that your status is set to Do not disturb. Other agents can still receive calls during this time.
- Open HyperConnect from Chat in the Zenoti navigation.
- Click the Settings icon in the app header.
- Select the User tab, then locate the Notifications section.
- Find the Do not disturb toggle.
- Do not disturb β Enable to stop receiving inbound calls when logged in. Other users can receive calls.
- Toggle Do not disturb on or off as needed.
- Click Save.
When Voice DND is active, a banner displays:
Your status is set to Do Not Disturb. To receive calls, disable Do Not Disturb.
Tip: Use Voice DND when you need uninterrupted time for tasks but want to remain logged in. Calls route to other available agents automatically.
Configure ring volume
Ring volume controls how loud the ringing sounds for inbound calls on your session. You can adjust this independently of your device's system volume.
- Open HyperConnect from Chat in the Zenoti navigation.
- Click the Settings icon in the app header.
- Select the User tab, then locate the Notifications section.
- Find the Ringer volume slider.
- Ringer volume β Adjust the ringer volume for incoming calls. The default is 100.
- Drag the slider to your preferred volume level.
- Click Save.
Note: Ring volume applies to the HyperConnect interface on your current session. It does not affect your device's system volume or the ring volume on a physical phone device.
Tips
- If you are stepping away briefly, enable Voice DND rather than logging out. This keeps your session active while routing calls to colleagues.
- Set ring volume to a lower level in open-plan environments to avoid disrupting nearby staff.
- If you are using a physical phone device, ring volume for that device is controlled separately through the device hardware. The Ringer volume slider in HyperConnect settings applies to the soft phone interface only.
- After enabling Voice DND, verify the banner appears at the top of the HyperConnect interface to confirm the setting is active.
- Both settings take effect immediately after saving β no page refresh is required.
Troubleshooting
| Problem | Resolution |
|---|---|
| Voice DND is on but you are still receiving calls | Confirm you clicked Save after toggling DND. Refresh the page and check the banner message. If the banner does not appear, the setting may not have saved. |
| Ring volume slider is at maximum but calls ring quietly | The Ringer volume slider controls the HyperConnect soft phone volume only. Check your device's system volume and browser tab audio settings. |
| The DND banner does not appear after enabling the setting | Clear your browser cache and reload HyperConnect. If the issue persists, contact your administrator to confirm your role has the Connect Access Enable permission. |