Zenoti University integration
Day-to-day operations for the Zenoti University (Northpass LMS) integration. Covers managing learning content, adjusting SSO, and handling sync or access failures. For initial setup see Configure Zenoti University.
On this page
- Before you begin
- Access Zenoti University settings
- Refresh the courses
- Manage groups
- Single sign-on
- Handle LMS failures
- Reconciliation
- Tips
Before you begin
Permission: You need organization administrator access to manage Zenoti University settings. Any user with training-assignment permission can enroll employees into existing groups.
- The integration must be configured. See Configure Zenoti University.
- You need the Northpass credentials and SSO configuration documented in the setup article.
Access Zenoti University settings
- Navigate to Configuration > Integrations > Integration settings, then search and expand Zenoti University.
- In Configuration, check that Active is Yes and use Test Connection to confirm the credentials still work.
Refresh the courses
- Open the Courses panel.
- Select Sync Courses to re-fetch the list after Northpass adds or retires courses.
- Select Save.
Manage groups
- Open the Groups panel.
- To create a group: select Add, name the group, choose its TYPE, pick the ROLES and COURSES it covers, and select Save. Employees in those roles are enrolled in the group's courses.
- To change a group: open it from the list, adjust its roles or courses, and save. Removing a role or course voids that assignment in Northpass.
- A role can belong to only one group; All Roles assigns every role to the group.
Single sign-on
There is no SSO switch on the Zenoti University accordion. When SAML is configured under Configuration > Integrations > Integration settings > SAML, employees who open Zenoti University from Zenoti reuse that sign-on; otherwise they sign in to Northpass with their Northpass credentials. Any change to SAML must be matched in Northpass and your identity provider. See SSO / authentication integration.
Handle LMS failures
| Failure mode | User-visible symptom | Resolution |
|---|---|---|
| Northpass API unreachable | Catalog fails to load; group creation fails. | Retry after a few minutes; if the outage persists, check Northpass status and retry later. |
| API key expired or revoked | Test Connection reports a communication failure and asks you to check credentials. | Ask your Northpass administrator to issue a new key and update API Key in the Configuration panel. |
| SSO assertion rejected | Employees are redirected back with a SAML error. | Confirm the IdP metadata in Northpass matches your identity provider; re-exchange metadata if needed. |
| Employee cannot see assigned courses | Group was created but Northpass provisioning did not complete. | Open the group, re-save it, and watch for the success message; run Sync Courses if the course list is stale. |
| Group provisioning rate-limited | Bulk group creation pauses. | Create groups in smaller batches. |
Reconciliation
| Source | Report / view | Match key | Cadence |
|---|---|---|---|
| Zenoti | Roles and courses listed per group in the Groups panel | Role + group name | Monthly |
| Northpass | Northpass admin portal > enrollment report | Employee email (the field Northpass uses) + group name | Monthly |
Investigate employees whose Zenoti role belongs to a group but who are missing from the corresponding Northpass group. Most commonly, these are provisioning failures that did not surface on the Zenoti side.
Tips
- Test the API connection after any credential change to ensure Northpass responds before relying on the integration.
- Organize groups by department or role to simplify training assignments.
- Monitor group enrollment in Northpass periodically to catch drift.